How To Fit A Toilet Pan To The Floor

The first step in removing an old toilet is to turn off the water at the shutoff valve located either on the wall or floor behind or beside the toilet.

How to fit a toilet pan to the floor.

This video covers how to install a toilet. Fit a new seal around the drain hole in the floor and make sure it s tight. How to attach them safely to the. Fit the toilet to the soil pipe and push it back to the wall into place grab a pencil and mark on the floor where the holes are.

Make sure the seat can remain in an upright position. Toilets should be caulked to the floor to prevent side to side movement that can break the wax seal and to prevent splashes or overflows from puddling under the toilet and rotting the floor. Attach the water inlet pipe taking care not to overtighten. To install a new toilet first turn off the water supply and remove the old toilet.

Level the toilet base then tighten the bolts and cap them. Connect the pan to the waste pipe using the pan connector. To fit a toilet with l shaped clamps simply. We would place the toilet pan on the floor and mark out the foot print with a pencil and the remove it again the next step would be to cut a hole in the floor under the pan for a key this would create a lock between the pan and the floor.

If the toilet flange sits below the finished floor the toilet will leak. This valve controls the flow of water into the supply line and then into the toilet tank. Includes how to remove a toilet bowl or pan and cistern and install the new ones. Flush the toilet to drain all the water from the tank and toilet bowl.

Turn on the water and check for leaks. That doesn t always provide a good enough bond to the floor. It s simple the watertight seal between the toilet bowl and wax ring will eventually fail. I can remember when i started my apprenticeship as a plumber every toilet pan was secured to the floor with a sand and cement mix mortar.

Steve used an oatey 4 replacement toilet flange for cast iron pipes. Then lift the toilet onto the floor bolts and jiggle it a bit to seal the drainage hole. Screws are then fixed into these brackets from the outside. In order for this not to happen the toilet flange must sit above the finished floor by at least 1 4.