How To Fix A Floor Lamp That Has 3 Bulbs

To replace a lamp socket follow these steps.

How to fix a floor lamp that has 3 bulbs.

Apart from the plug on the other end there is not a great deal that can go wrong with any other parts of a lamp. Get the new socket the one with. Taking the time to rewire an old floor lamp is easier than it may sound. You can begin repairing a floor lamp by disassembling the lamp.

If it continues to flicker or the lamp emits sparks makes a humming noise or trips a circuit breaker the lamp needs repair work. Unplug the lamp and remove the lampshade. Disassemble the lamp and remove the old wires. Unscrew the nut and lift off the shade or top.

Remove the shade or top of the floor lamp. There is a plug an electrical cord a socket and a light bulb. Remove the lampshade the shade mounting rod and the light bulb from the lamp. How to rewire an old floor lamp.

Table lamps by themselves are fairly simple electronic devices. Then pop the outer shells off the bulb sockets exposing the inner metal socket and the wire connections. Remove the cap on the wire connection housing usually this is a simple pop off cap. Some have dimmer switches built into the shaft and others have a rocker switch at the.

With a few simple steps you can breathe new life into your old lamp. A majority of floor lamps are comprised of threaded pipes joined by screws. Disconnect the lamp s power cord from the electrical outlet. Make sure the cord is protected by a screw on bushing where it enters the threaded tube and by a plastic or rubber grommet through the lamp body photo 1.

You may have a favorite vintage floor lamp and cannot bare to part with it but it doesn t work anymore. If any one of these items has been compromised the bulb will flicker. Do not lose any of the pieces. Run it in the lamp and then through the socket.

The main components in a lamp fitting are the cord the lamp switch and the bulb. You can probably get the right replacement parts most easily by taking the lamp apart according to the following directions and bringing the bad parts to the store so that you can find matching replacements. Get the new wires. To take it apart start by taking the screws off the foundation.

Remove the light bulb from the socket. 2 slip a small flat head screwdriver in between the. Usually there is a nut that holds a shade on or if the lamp has an open glass top there is a nut around the socket. If a bulb flickers when you turn on the lamp you may only need to tighten the bulb in its socket.

If you could turn the lamp on to several degrees of brightness be sure to purchase a socket switch that s designed to control a three way bulb.