How To Install Shutter Anchors Through Tile Floor

Repeat for other shutters.

How to install shutter anchors through tile floor.

Drive 3 inch screws through the wood and into the tile to anchor the wood frame to the floor. The anchor will be flush with the tile once fully inserted. A correct rod placement is when your curtain rests just above the floor or so that when the shower is running all of the water is contained in the shower area. Step 3 installing the anchor screw.

Use a hammer to gently tap the fasteners to snug the shutter to the siding. Use the screwdriver to insert the anchor screw. 8 set the cabinets on the wooden frame and align flush with the framing lumber. Insert the screw into the anchor and twist a few times so it will stay.

An alternative to drilling into your tile is to use a tensioned shower curtain rod. Place the anchor screw in the pilot hole. The anchor screw should be the same size as the screw you will be using. 5 keep the drill cool while drilling through the tile by dipping it into water frequently.

A smaller or larger anchor screw will simply cause the screw to either break the tile or fall from the anchor. Finish installing the screw with a screwdriver until it is flush. Typical drive in plastic anchors require a 1 4 or 5 16 inch 0 6 or 0 8 cm hole molly anchors and other expansion anchors may require larger holes to allow them to expand properly.