I am happy to say that i was right and it took the paint right off with no long waiting no covering it up to keep from evaporating.
How to get paint off hardwood floors safely.
If you find the paint before it dries you ll likely be able to clean it off with just some water.
Once the paint has dried you have to either scrape it or dissolve it.
The paint should be now easy to lift off the floor due to softening by the soapy water.
Lastly use a blunt knife to scratch off the paint layer and sweep off the floor surface.
Remove stuck on residue.
If you re painting the walls or the trim in your home it s not uncommon for some paint to drip onto your laminate flooring.
The best time to remove paint from a floor is when it s still wet.
If that doesn t take the paint off use a rag to blot denatured alcohol on the stain let it soak in for a few minutes then scrub it with a brush.
This is a quicker way to remove dried paint off the hardwood floors.
The easiest way to get dried paint off of hardwood floors.
Use of commercial paint removers.
Dried paint can be a challenge to remove from hardwood flooring without causing major damage especially if the paint is oil based.
If you catch it early you can use a damp rag to wipe it up.
Visit one of the home improvement stores and buy a paint remover.
Because different floor finishes have unique care requirements the best way to clean hardwood floors will depend on the type of finish rather than the wood species e g cherry maple oak.
Many chemical cleaners are too harsh to use on this type of floor but there are methods to safely lift dried paint.
Start with dish soap and warm water blotting up as much as possible.
Learn how to get paint off wood floors by following these trusted tips.
However i came across a cleaning fluid i haven t used in years and from past experiences with it i had a feeling this stuff would take the paint off my wood floors.
Wood floors can be beautiful and warm underfoot and they are relatively easy to care for.
Removing paint spills from linoleum or vinyl floors without damaging the surface can be tricky.